Red Sea Reefwave 25 Controller
Fits
Red Sea ReefWave 25
Part no.
R35230
Voltage
230-240 V, 50 Hz (AU mains, via ReefWave 25 power supply)
Genuine part
Yes, genuine Red Sea
Red Sea Reefwave 25 Controller
This is the genuine Red Sea controller for the ReefWave 25 wavemaker, confirmed as part number R35230 in Red Sea's own ReefWave manual and spare parts documentation. It runs the pump's flow, wave patterns and feed-mode schedules, and pairs with the ReefBeat app for full smart control. Use it to replace a ReefWave 25 controller that has failed or been damaged - it is not a match for the ReefWave 45.
Key features
- Genuine Red Sea controller, confirmed factory part R35230
- Full wave, schedule and feed-mode control for the ReefWave 25 pump
- ReefBeat app connectivity for remote monitoring and adjustment
- Direct plug-in replacement - no pump disassembly required
Specifications
| Attribute | Detail |
|---|---|
| Genuine part number | R35230 (per Red Sea ReefWave manual, spare parts list) |
| Fits | Red Sea ReefWave 25 pump only |
| Voltage | Runs on the ReefWave 25 power supply, 230-240 V, 50 Hz AU mains input |
| Connectivity | ReefBeat app |
Will it fit my tank?
Confirmed against Red Sea's official ReefWave manual and spare parts list: this is the ReefWave 25 controller, part R35230. The ReefWave 45 uses a different controller, part R35241, so this unit will not run a ReefWave 45 pump. If unsure which pump is fitted, check the model printed on the pump housing before ordering.
Safety
This is a mains-powered accessory. Fit it on a residual current device (RCD, also called a safety switch), mount it clear of splash zones above the waterline, and run a drip loop in every cable before it reaches the controller or power point. Most electronics failures in fish rooms come from water tracking down a cable rather than from the unit itself.
Warranty and delivery
This controller is covered by Red Sea's manufacturer warranty in addition to your rights under Australian Consumer Law. Contact us with your order details for warranty support or delivery timing.
Common questions
Is this the genuine Red Sea part?
Yes. It is listed in Red Sea's own ReefWave manual and spare parts documentation as part number R35230, the ReefWave 25 controller.
Does this fit the ReefWave 45?
No. The ReefWave 45 uses a different controller, part R35241, per the same Red Sea documentation. This listing is for the ReefWave 25 only.
Will this work with my existing ReefWave 25 pump and power supply?
Yes, it is a direct plug-in replacement that runs on the existing ReefWave 25 power supply and connects to the pump the same way as the original controller.
Do I need to set it up in the ReefBeat app?
Yes, set up the new controller in the ReefBeat app as you would any ReefWave 25 controller; see Red Sea's manual for pairing steps.
