Fits
Red Sea ReefWave 45
Part no.
R35244
Red Sea Reefwave 45 Rotor Shaft/Magnet
The single wear part behind ReefWave 45 rattle, wobble or rough start-up. This is the genuine Red Sea rotor – shaft and magnet – for the ReefWave 45 gyre pump, Red Sea part number R35244. It's the one internal component that wears with running hours, and replacing it is the most common fix for a ReefWave that's gone from silent to noisy.
Key features
- Genuine Red Sea part – factory rotor, shaft and magnet assembly, not a generic substitute.
- Cures the common symptoms – rattle, vibration, wobble and hesitant start-up on power-up.
- Primary wear component – the part that ages fastest inside the ReefWave 45's wet-side motor.
- Simple DIY fit – no specialist tools beyond what's needed to open the pump housing during a routine service.
Will it fit my pump?
| Fits | Red Sea part number |
|---|---|
| ReefWave 45 | R35244 |
This rotor is sized for the ReefWave 45 only. The smaller ReefWave 25 uses a different rotor, Red Sea part R35233 – check the model printed on your pump body before ordering, since the two are not interchangeable.
Specifications
| Genuine part number | R35244 |
|---|---|
| Component | Rotor – shaft and magnet assembly |
| Fits | Red Sea ReefWave 45 |
| Fitting | DIY, no specialist tools required |
Care and maintenance
Red Sea recommends servicing the ReefWave 45 annually, descaling the wet-side components in a dilute citric acid solution and replacing the rotor and O-rings together rather than waiting for a fault to appear. The ReefWave 45 Service Pack bundles the O-rings, bushes and connectors normally replaced at the same time as this rotor.
Suitable for, and not suitable for
Suitable as a routine annual service part or as a fix for an existing ReefWave 45 that has started rattling or running rough. Not suitable for the ReefWave 25 – order R35233 for that model instead.
Warranty and delivery
Covered by Red Sea's manufacturer warranty on parts, in addition to your consumer guarantee rights under Australian Consumer Law. Ships as a small parcel item, standard delivery.
Goes well with
- Red Sea ReefWave 45 Service Pack – the O-rings, bushes and connectors serviced alongside this rotor
- Red Sea ReefWave 45 Snail Guards – protects the rotor and impeller from snail ingestion
Common questions
How do I know if my ReefWave 45 needs a new rotor?
Rattling, a grinding or knocking noise, visible wobble in the flow, or the pump hesitating on start-up are the usual signs the rotor's bearing surfaces have worn.
Does this fit the ReefWave 25?
No. The ReefWave 25 uses a different rotor, Red Sea part R35233. This listing is for the ReefWave 45 only, part R35244.
Should I replace anything else at the same time?
Red Sea's service kit for the ReefWave 45 bundles the O-rings, bushes and connectors typically due at the same interval – worth fitting together rather than opening the pump twice.




