Aqua Medic Injection Set
Water type
Freshwater + Marine
Part no.
39060
Aqua Medic Injection Set
Six precision syringes and fine cannulas for dosing, sampling and electrode maintenance around the reef tank. The Aqua Medic Injection Set is a six-piece syringe kit sized from 1 mL to 50 mL, built for the small jobs a reef tank generates every week — topping up trace elements, spot-dosing coral food, drawing a water sample, or refilling the electrolyte in a refillable pH or mV electrode. A length of silicone tubing is included so any syringe can be extended to reach a sump or a hard-to-reach dosing port.
Key features
- Six syringe sizes — 1 mL, 2.5 mL, 5 mL, 10 mL, 20 mL and 50 mL cover everything from a single drop of trace element to a full water sample.
- Six fine cannulas — saltwater-resistant plastic, sized to fit the syringe range, for precise spot-dosing into small vessels or coral polyps.
- 50 cm silicone tubing — 4 mm inner diameter, 6 mm outer diameter, extends any syringe's reach into a sump or dosing container.
- Electrode-safe use — sized to draw and refill the electrolyte in refillable Aqua Medic pH and mV/ORP probes without spilling.
- Reusable and saltwater-resistant — rinses clean between uses and holds up to reef-tank conditions better than kitchen syringes.
Specifications
| Syringes included | 1 mL, 2.5 mL, 5 mL, 10 mL, 20 mL, 50 mL |
|---|---|
| Cannulas included | 6, saltwater-resistant plastic |
| Tubing | Silicone, 50 cm length, 4 mm ID / 6 mm OD |
| Material | Plastic syringes and cannulas, silicone tubing |
| Item code | 39060 |
What's included
Six syringes (1–50 mL), six fine cannulas and one 50 cm length of silicone tubing, packed together as a set.
Suitable for, and not suitable for
Suited to freshwater and marine aquariums alike — dosing trace elements and coral food, sampling tank water for testing, and refilling refillable pH or mV/ORP electrodes. Not intended for dosing medications at prescribed veterinary volumes, and not a substitute for a calibrated dosing pump where consistent, repeated dosing is needed.
Care and maintenance
Rinse syringes and cannulas in fresh water after each use, especially after contact with saltwater or supplements, and let them air-dry fully before storing. Replace a syringe if its plunger seal starts to leak or stick.
Goes well with
- Aqua Medic KCL Solution for pH & mV Probes 60 mL — for calibrating the electrode you're refilling.
- Aqua Medic mV Monitor or mV Computer-Set — the refillable electrodes these syringes are sized for.
Warranty and delivery
Covered by the Aqua Medic manufacturer warranty against defects, in addition to your rights under the Australian Consumer Law. Standard parcel delivery Australia-wide.
Common questions
Can I use these syringes to dose two-part or trace element supplements?
Yes. The 1 mL to 20 mL sizes suit typical daily dosing volumes; use the fine cannula for precise, drip-free dosing at the sump or dosing port.
Will the tubing fit onto a dosing pump?
The 4 mm ID / 6 mm OD silicone tubing suits most syringe and small-bore dosing connections, but check your dosing pump's specified hose size before assuming a fit.
Are the cannulas reusable?
Yes, they're saltwater-resistant plastic and can be rinsed and reused, though like any fine-bore cannula they should be replaced if they become blocked or blunt.
Can I use these to refill a non-Aqua Medic electrode?
The syringe and cannula sizes are general-purpose, but always check your specific electrode manufacturer's refill instructions before topping up electrolyte.
