Aqua Medic Extension Cable 1.8m - EcoDrift & DC Runner
Fits
EcoDrift x.1, EcoDrift x.2, EcoDrift x.3, DC Runner x.1, DC Runner x.2, DC Runner x.3, SmartDrift x.1
Part no.
100.301
Aqua Medic Extension Cable 1.8m - EcoDrift & DC Runner
Extra reach for an EcoDrift, DC Runner or SmartDrift pump without re-running the whole cable. This 1.8 m Aqua Medic extension cable fits between the pump and its controller, letting you mount the controller further away — useful where a cabinet door, a stand wall or a tight sump chamber puts the standard cable length just out of reach.
Key features
- 1.8 m length — adds reach between pump and controller without needing a new pump cable.
- Genuine Aqua Medic part — matched connector and cable rating to the EcoDrift, DC Runner and SmartDrift range, part number 100.301.
Specifications
| Spec | Detail |
|---|---|
| Length | 1.8 m |
| Part number | 100.301 |
| Fits | EcoDrift x.1, x.2, x.3 · DC Runner x.1, x.2, x.3 · SmartDrift x.1 |
Compatibility, spares and supersession
Fits the EcoDrift x.1, x.2 and x.3 series, the DC Runner x.1, x.2 and x.3 series, and the SmartDrift x.1 pumps and controllers. Check your pump's model plate against this list before ordering — earlier Aqua Medic pump generations use a different connector.
Suitable for, and not suitable for
Suitable for extending the run between an EcoDrift, DC Runner or SmartDrift pump and its controller.
Aqua Medic specifies a maximum of one extension cable per controller — daisy-chaining two extension cables onto the same pump is outside the manufacturer's rated setup and is not supported.
Goes well with
Pairs with any Aqua Medic EcoDrift, DC Runner or SmartDrift pump where the factory cable doesn't reach the intended controller position.
Warranty and delivery
Covered by Aqua Medic's manufacturer warranty against defects, in addition to your rights under Australian Consumer Law. Ships as a small parcel item.
Common questions
Can I connect two extension cables together for more reach?
No. Aqua Medic rates a maximum of one extension cable per controller; running two in series is not a supported configuration.
Does this cable work with older Aqua Medic pumps?
It's matched to the EcoDrift, DC Runner and SmartDrift x.1/x.2/x.3 connector. Check your pump's model and generation against the fits list above before ordering.
Does this cable carry power or just the control signal?
It's the link between the pump and its controller, carrying both the pump connection and control signal for that pairing — it does not connect to household mains directly.
